26
d.2 DJ Mixer
d.2 2-channel DJ Mixer
Replacing Faders
If the faders ever need to be replaced, this can be
done with the help of your trusty screwdriver.
10. Follow steps 1 to 5 and remove the top panel.
11. Take care to only remove the two outer screws
of each fader you are replacing, as shown below.
12. Gently lift up the fader assembly, just enough to
be able to pull the connector out of the recep-
tacle on the bottom of the fader assembly.
13. Insert the connector into the receptacle on the
new fader assembly. (It will only fi t in one way.)
14. Secure the fader assembly to the chassis with
the two screws you lost in step 11.
15. Replace the top cover, and make sure that all
the meter LEDs and the Reverse LEDs are pok-
ing through before you tighten down the screws
securely.
16. Check that all the faders and switches are
working normally. (You might have to reset the
tension if you changed the cross fader.)
Removing the Cross Fader Connector
Removing a Program Fader Connector