SYSTEM OPERATION
SPECIFICATIONS
The Audioaccess
ON
(Substitute the word POWER for PX-600 front panel operation)
▲To turn on a single zone, momentarily press the ON button. The ON LED will illuminate on keypads. The FM (TUNER on front panel) will be selected when a zone is first turned on.
▲To turn off a single zone, momentarily press the ON button again.
▲To turn on a group of zones (this is called an ALL ON group), start with the zone off, then
▲To turn off an ALL ON group, momentarily press the ON button from any zone within the group.1
▲To turn off all zones in the system, as well as the power to the source components, regardless of ALL ON grouping, go to any keypad, make sure it is ON, then
1Certain options are available that affect the opera- tion of ALL ON. For example, if your system is programmed with the TIMEOUT feature, the zones in an ALL ON group may be set up to revert back to independent operation 30 seconds after the ALL ON is initiated. If this is the case, momentarily pressing the ON button will only turn off the zone you’re in. Check with your dealer for further information.
VOLUME ▲ ▼
▲To increase the volume, press ▲. To decrease the volume press ▼. (On the front panel use the large knob.)
▲To mute the audio, press ▲ and ▼ together. (Press the MUTE button on the front panel or IR remote control to get the same response.)
▲To
Audio Section
Inputs:
▲Five stereo source inputs, 1 mono page input, each with loopthru capability
▲Input impedance: 10k Ω
▲Maximum input voltage: 3.5 Vrms
Outputs:
▲Six stereo preamp outputs with independent volume, bass and treble
▲Six stereo zone outputs (fixed level, post input selector)
▲Tape output from the main zone (zone 6)
Source Equipment Control and Interface Section
Inputs:
▲Trigger input to facilitate sharing source equipment (controls switched outlet and "stop" commands)
▲Keypad interface connector
▲DC voltage input for zone trigger outputs
▲Hardwired IR input to control main zone from industry standard IR receivers
Outputs:
▲Trigger output from each zone to control external relays
▲One system trigger output to control exter- nal relay (active when system is on)
▲Six infrared emitter jacks, one for each audio source (5) plus ALL
▲IR loopthru output
▲Switched outlet (North American model only)
3
8