A |
ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave fin- gers on or near electrode wire while engaging igniter.
•Electrode wire should be approximately 1/8” from gas exit hole in burner. Carefully adjust wire if required.
DISASSEMBLY & RE-ASSEMBLY
•Lift radiant plate up & out of left slot (see B) and remove by sliding it out of right slot (see C).
•Remove burner screw (see B) and remove burner. Check burner for grease residue or spider webs that may obstruct gas flow. CAUTION: WHEN REPLAC-
ING BURNER, CUT SLOT IN BURNER MUST FACE DOWN.
•To remove liner from outer shell you must disconnect the electrode wire (see D). First remove the two screws on valve chamber (see D) and remove the cover plate. Gently pull wire off connector (see D). It is not necessary to remove electrode from liner.
•Remove Lid and liner by removing hinge screws and lock nuts with 3/16” hex key wrench (supplied) and 1/2” wrench or pliers. CAUTION: LOCK NUTS MUST BE INSTALLED WITH LOCKING INDENT MARKS SHOWING (see E).
IMPROPER INSTALLATION WILL DAMAGE THE HINGE SCREW AND LOCK NUT.
•Lift liner out of outer shell by lifting up on liner lip on back side of liner
(see F). When replacing liner, be sure top lip of liner installs over top edge of outer shell (start with corners of lip and work in).
•Inspect burner, remove any obstructions.
•Clean as indicated in Maintenance (page 6).
•To
B
Left side slot
C
Right side slot
DDisconnect wire
Burner screw
Electrodel
Screws
E
Locking
Indents
F
Liner Lip
Liner
Outer Shell
5
