FINGER REMOVAL AND DISASSEMBLY FOR CLEANING
1.Open door and remove upper fingers. Note any particular placement of fingers that you may have, such as fully closed,
2.Remove conveyor and then remove bottom fingers.
3.For finger disassembly, see page 11, figures 6, 7, and 8.
4.Reassemble fingers in reverse order with the step of the columnating plate facing downward so it fits under the lip of the finger housing.
5.
CONVEYOR DISASSEMBLY FOR CLEANING
TO REMOVE CONVEYOR FROM OVEN
1.Remove conveyor chain guard. Remove crumb pans.
3.Lift right end of conveyor and push in approximately 3” (76 mm). Remove drive chain.
2.Next, slide the conveyor
counterclockwise to the up position.
4.Pull conveyor out the right end. Place on table or work surface.
NOTE: For the Model 1200 Series, steps 3 and 4 are performed on the left end of conveyor.
TO REMOVE CONVEYOR BELT
5. Locate connecting links on the conveyor belt, turn | 6. On Model Series 1000 ONLY, loosen jam nut and |
belt to place the links on the top left end of the | unscrew the tension adjustment screws. Push the idler |
conveyor, approximately 8” (203 mm) from the | shaft in against the conveyor support bars. |
shaft. | 7. You can easily remove the connecting links by grasping |
| |
| them with a pair of pliers and slipping the eye of the |
| connecting link over the wire of the other links. Also |
| notice the direction of the opening on the links. – The |
| belts will have to be reinstalled with the opening facing |
| the same way. |
| Carefully pull out the belt, rolling it up as you go. After |
| removal, it may be placed in a pan of detergent solution |
| to soak. Rinse with clean water. |
16 | Impinger I – 1000 Series Ops Manual |