CONVEYOR REASSEMBLY
CONVEYOR BELT INSTALLATION
1.Put conveyor belt back on by setting the rolled belt to the left of the conveyor and thread approximately 2/3 of the belt over the bottom slider bed.
Put the loose end of the belt around the idler shaft and back on the conveyor. The belt must lay on top of the upper conveyor slider bed.
NOTE: The belt should curl around the conveyor sprockets and lay flat on top of the sprockets. If the belting does not curl around the sprockets and lay flat, remove the belting and turn the belting over. Reinstall.
Pull all of the slack belt through the conveyor until both ends are on top of the conveyor on the left end.
TO INSTALL CONVEYOR IN OVEN
5.Insert the conveyor through the opening in the right side. Sprocket should be to the right side of the conveyor. NOTE: For Model Series 1200, step 1 is performed on the left end of the conveyor.
6.Slide conveyor through the oven chamber until the locking bar on driving end of the conveyor is approximately 2” – 3” (50 – 76 mm) into the oven chamber. Install drive chain by placing it over the driving sprocket and placing it over the conveyor sprocket.
2.Replace belt and reconnect splice clips as shown in step 7 on page 16.
3.The conveyor has no adjustments (Series 1200 and 1400). If belt becomes too tight or loose, a link will have to be installed or removed. Proper tension allows the belt to be lifted within ¼” from the top of the conveyor opening.
4.Model 1000 Series Only: Pull idler shaft toward the end of the conveyor and screw tension adjustment knobs back in. DO NOT OVER TIGHTEN BELT!
Tighten the jam nuts against the adjustment plate.
7.Lift conveyor just enough to allow you to pull the conveyor toward you until the locking bar is outside of the oven cavity, at the same time push the conveyor downward so that the bar locks on the outside of the oven wall. Next, slide the conveyor
8.Reinstall conveyor crumb pans and chain guard cover.
! | CAUTION: | SET TENSION ON THE CONVEYOR BELT. THE BELT SHOULD BE ABLE TO BE |
| ||
| CONVEYOR OPENING ON THE OVEN. DO NOT OVER TIGHTEN BELT! | |
|
| LIFTED ENOUGH TO ALLOW IT TO BE ¼” (6 MM) FROM THE TOP OF THE |
Impinger I – 1000 Series Ops Manual | 17 |
