System Status Check (Continued)
1. First press the SET button on the transmitter, within 3 seconds press the 
buttons to activate outdoor driver paging function. The vehicle will then respond with chirps from the
horn/siren and a melody sound from the LCD transmitter. The | icon will then appear on the |
LCD transmitter screen. |
|
2.When the windshield knock sensor is activated, the vehicle will then respond with chirps from
the horn/siren and a melody sound from the LCD transmitter. The 
icon will then appear on the LCD transmitter screen.
3.A. Turn on the ignition switch or press the 
button to arm the system.
B. Press the 
button to disarm the system. This will then exit this function.
Dome Light Supervision
The Security System has a unique feature for using your vehicle’s dome light.
1.Upon disarming the vehicles security system, the interior dome light will remain on for thirty seconds.
2.If the security system is triggered, the dome light will flash for the same duration as the horn/siren.
Ignition Controlled Door Locks
If the vehicles door locks have been interfaced with the security system, the system will automatically lock the vehicle’s doors when the ignition key is turned to the “ON” position and or unlock the doors when ignition key is turned to the “OFF” position.
Channel 3: Trunk Release Output
Press and hold the 
button for two seconds to activate the trunk release (Channel 3 output) and/or any other devices connected.
Channel 4: Timer Control Output
Press and hold the 
and 
button at the same time to activate the Channel 4 output.
Channel 4 is user programmable output. You may program the built in timer to send a ground signal for any time duration from 1 second to 120 seconds.
Channel 5: Timer Control Output
Press and hold the 
and 
button at the same time to activate the Channel 5 output. Channel 5 is user programmable output. You may program the built in timer to send a ground signal for any time duration from 1 second to 120 seconds.
Channel 6: Timer Control Output
Press and hold the 
and 
button at the same time to activate the Channel 6 output. Channel 6 is user programmable output. You may program the built in timer to send a ground signal for any time duration from 1 second to 120 seconds.
Note: These timer outputs
11
