Wiring Instructions
Power Harness Wiring:
The 3 wire harness provides battery and igni- tion 12 volts as well as a chassis ground. Route the power harness to the point in the vehicle that you will make the connections.
Red Wire: The red wire in the harness should be connected to a +12 volt power wire that is turned on and of by the position of the ignition key.
Yellow Wire: The yellow wire in the harness should be connected to a constant +12 volt wire that is NOT turned on and off by the position of the ignition key.
Black Wire: The black wire in the harness should be connected to the chassis of the vehicle using a ring terminal and self tap- ping screw or existing bolt and nut.
Dome Light Harness Wiring:
Follow the enclosed wiring to connect the MovieVision dome light system to the factory installed dome light wiring
For Negative Trigger Dome Light Systems (typical to most vehicles):
Orange Wire: Connect to constant +12 volts.
Green Wire: Connect to the common trigger wire coming from all door pin switches
White Wire: Connect to chassis ground.
For Positive Trigger Dome Light Systems (typical to many Ford vehicles):
Orange Wire: Connect to chassis ground.
Green Wire: Connect to the common trigger wire coming from all door pin switches (+).
White Wire: Connect to constant +12 volts.
Auxiliary Input:
You may use video games, camcorders and other portable video unit by connecting the unit to the
Note: These connectors are attached to black wires.
Yellow RCA Connector: Video input.
Red RCA Connector: Audio input right.
White RCA Connector: Audio input left.
Video Output:
You may output video to an optional monitor.
Note: This connector is attached to a gray wire.
Yellow RCA Connector: Video output.
9
