Magnavox 32MD359B 5Supplied Accessories, 5Attaching the Stand, To remove the stand from this unit

INTRODUCTION

5Supplied Accessories

user manual	quick start guide	remote control	registration card	Phillips pan screw for
(1EMN24199)	(1EMN24379)	(NF801UD)	(1EMN24699)	attaching the stand x 4
				(FPH34200)

batteries (AAA x 2)

AAA

AAA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

5Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.

1Spread a thick and soft cloth over a table.

Place the main unit face down onto it. Make sure not to damage the screen. At least two people are required at this step.

2Hang the hook under the bottom of the main unit to the stand’s hole (shown arrow ➀), then slide down the stand in the direction of the screen (shown arrow ➁).

Make sure not to put the AC power cord between the stand and the unit.

3Drive Phillips pan screws in the 4 threaded holes at the bottom of the stand with a screwdriver tightly.

Žscrew holes



front side

Œ

Œ

To remove the stand from this unit

Unscrew the Phillips pan screws indicated by “➂”. Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand when you remove it.

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

6

EN