Magnavox MWR20V6 manual Installing batteries in the remote control, Using a remote control, 10 EN

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two “AAA” size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1 2 3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23 feet (7m)

	30°
Remote	30°
control

The VCR/DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [SOURCE].

VCR MODE

Press [VCR] on the remote control. (Verify that the VCR indicator is lit.)

DVD MODE

Press [DVD] on the remote control. (Verify that the DVD indicator is lit.)

Note:

•Pressing only [SOURCE] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

•You cannot switch to another mode (DVD or VCR) during in the timer-standby mode.

•Pressing [DVD REC I] or [VCR REC I] on the remote control switches immediately its respective mode so that you can start recording directly on the appropriate media.

DVD button

VCR button

VCR SOURCE DVD

DVD indicator

SOURCE button

VCR indicator

		STANDBY-ON
VIDEO/TV	VCR	DVD	OPEN/CLOSE
.@/:	ABC		DEF
1		2	3
GHI	JKL		MNO
4		5	6
PQRS	TUV		WXYZ
7		8	9
CLEAR/C-RESET SPACE			TITLE
		0
RETURN			DISPLAY
	OK
DISC MENU			SETUP
	CHANNEL
TIMER	VCR REC	DVD REC	REC MODE
TIMER SET	SLOW	CM SKIP	RAPID PLAY
SEARCH	AUDIO	DUBBING

10 EN