Magnavox VRZ263AT99 owner manual Setting Up the VCR Plus+ Programming System cont’d

VRZ263(H1955).QX33 4/9/99 9:43 AM Page 35

Setting Up the VCR Plus+ Programming System (cont’d) 35

2

Now, compare the channel numbers you have written in the VCR PLUS+ CH. and CABLE/TV CH. columns. For stations whose VCR Plus+ and Cable/TV channels do not match, you must tell the VCR the VCR Plus+ and Cable/TV channel numbers by following steps 3 - 7. Make each entry within 60 seconds of the previous entry.

3

Press the VCR button, then press the MENU button.

4

Press the PLAY/o button or the STOP/p button to select VCR SET UP, then press the F.FWD/B button.

SELECT op CHOOSE B

→ REPEAT PLAY OFF

ON SCREEN MODE AUDIO OUT LANGUAGE

VCR PLUS+ REF. MAP TO END PUSH EXIT

5

Press the PLAY/o button or the STOP/p button to select VCR PLUS+ REF. MAP, then press the F.FWD/B button.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

9898

9999

1 – – – – –> 1

22

TO SELECT CH PUSH op

THEN ENTER CH NO. TO END PUSH EXIT

2 Examine the lists on page 34.

4-5

POWER	VCR	TV	CBL/DBS
	2	3	VCR/TV
1
4	5	6
			CHANNEL
7	8	9
VCR PLUS+
/ENTER

0+100

SPEED TIME SEARCH MUTE VOLUME

6		PLAY
	REW			F.FWD
		STOP
3	REC/OTR	MEMORY	SLOW	PAUSE/STILL
	MENU	STATUS/EXIT	CLEAR	EJECT
7

6

Look at the lists you filled in on page 34. For stations whose

VCR Plus+ and Cable/TV channels do not match, press the PLAY/o button or the STOP/p button until the arrow is beside the VCR Plus+ channel you need. Then, press the Number buttons to enter the corresponding Cable/TV channel from your list. (Enter a “0” before single- digit channels.) Enter all the stations on your list.

Note: If you are using a Cable Box/DBS, the Cable/TV channel will be 03 or 04 (the Cable Box/DBS output channel) for every VCR Plus+ channel. You must set the Cable Box/DBS to the channel you want to record; leave the Cable Box/DBS on for the timer recording.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

9898

9999

1– – – – –> 23

22

TO SELECT CH PUSH op

THEN ENTER CH NO.

TO END PUSH EXIT

7

Helpful Hints

•To erase a Cable/TV channel num- ber, repeat steps 3-5 on this page. Then, press the PLAY/o button or the STOP/p button to select it.

Press the CLEAR button, then press the STATUS/EXIT button.

•To select line input for the Cable/TV channel, press 0,0. AUX will appear on-screen.

•When you receive the VCR, all the VCR Plus+ channel numbers and Cable/TV channel numbers are the same.

Press the STATUS/EXIT button.