Adjusting depth of cut
Depth of cut may be adjusted by simply turning the knob on the front of the tool.
Adjusting front base
1.To create a curved surface, loosen the wing nut. For a concave planing job, raise the front base; for a convex plan- ing job, lower the front base. In either case, the front base must be aligned with the cutting line. Then tighten the wing nut securely.
NOTE:
As explained later, although the objec- tive is to cut until the cutting line is eventually reached, the planing must take place gradually.
II | Convex | w\ |
Cutting line | ||
I |
| WlnO nut |
I | Concave | |
Cutting line |
6
