15
1. Remove blade guard.
2. Attach auxiliary fence to rip fence for cuts that run
the length of the stock. Facing should be as high as
the workpiece is wide. Adjust fence and blade to
desired dimensions.
3. First cut: Hold board flat on table as in ordinary rip-
ping.
4. Second cut: Set workpiece on its edge. (Use feath-
erboards, push stick, push block and so on, using
precautions, safety rules and guidelines for ripping
or related work.)
5. For end-type rabbeting, if the workpiece is less than
10-1/2” wide, rest the wood flat on the table against
the miter gauge (with wood facing). The rip fence
should not be used.
6. After rabbeting is completed, immediately re-install
the blade guard as before.
•Steel & Carbide-tipped saw blades
C00269
•Sub table ( L)
•Sub table ( back)
•Rip fence
•Miter gauge
•Offset wrench 13-22
•Wrench 19
•Hex wrench 5
•Auxiliary plate
EN0006-1
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Poli cy
Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period of
ONE YEAR from the date of original purchase. Should
any trouble develop during this one year period, return
the COMPLETE tool, freight prepaid, to one of Makita’s
Factory or Authorized Service Centers. If inspection
shows the trouble is caused by defective workmanship or
material, Makita will repair (or at our option, replace)
without charge.
This Warranty does not apply where:
•repairs have been made or attempted by others:
•repairs are required because of normal wear and
tear:
•the tool has been abused, misused or improperly
maintained:
•alterations have been made to the tool.
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAM-
AGES FROM THE SALE OR USE OF THE PRODUCT.
THIS DISCLAIMER APPLIES BOTH DURING AND
AFTER THE TERM OF THIS WARRANTY.
MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
WARRANTIES, INCLUDING IMPLIED WARRANTIES
OF “MERCHANTABILITY” AND “FITNESS FOR A SPE-
CIFIC PURPOSE,” AFTER THE ONE YEAR TERM OF
THIS WARRANTY.
This Warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limi-
tation or exclusion may not apply to you. Some states do
not allow limitation on how long an implied warranty lasts,
so the above limitation may not apply to you.
Table /Mi ter s aw
blades
For general purpose cuts for table and
miter saws.
Combination General purpose blade for fast and
smooth rip, crosscuts and miters.
Fine cross cuts For sand-free cuts cleanly against the
grain.