Makita 3606 ASSEMBLY , OPERATION

To start the tool, move the switch lever to the I (ON) position.

To stop the tool, move the switch lever to the O (OFF) posi-

tion.

ASSEMBLY CAUTION:

•Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

CAUTION:

•Install the bit securely. Always use only the wrench

provided with the tool. A loose or overtightened bit can

be dangerous.

•Do not tighten the collet nut without inserting a bit, or the

collet cone will break.

Insert the bit all the way into the collet cone. Press the shaft

lock to keep the shaft stationary and use the wrench to

tighten the collet nut securely.

To remove the bit, follow the installation procedure in reverse.

OPERATION Set the tool base on the workpiece to be cut without the bit

making any contact. Then turn the tool on and wait until the

bit attains full speed. Move the tool forward over the work-

piece surface, keeping the tool base flush and advancing

smoothly until the cutting is complete.

When doing edge cutting, the workpiece surface should be

on the left side of the bit in the feed direction.

1. Shaft lock

2. Bit

003669

1. Workpiece 2. Bit revolving direction

3. View from the top of the tool 4. Feed direction

001984