ADDITIONAL SAFETY RULES
1.Wear hearing protection during extended periods of operation.
2.Handle the bits very carefully.
3.Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately.
4.Avoid cutting nails. Inspect for and remove all nails from the workpiece before operation.
5.Hold the tool firmly.
6.Keep hands away from rotating parts.
7.Make sure the bit is not contacting the workpiece before the switch is turned
On.
8.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit.
9.Be careful of the bit rotating direction and the feed direction.
IO. Do not leave the tool running. Operate the tool only when
11.Always switch off and wait for the bit t o come t o a complete stop before removing the tool from workpiece.
12.Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin.
13.Don’t smear the tool base carelessly with thinner, gasoline, oil or the like. They may cause cracks in the tool base.
SAVE THESE INSTRUCTIONS.
A
