Installing or removing battery cartridge | I | |
*Always switch off the tool before inser- | Set d a t e | |
tion or removal of the battery cartridge. | ||
/ | ||
To remove the battery cartridge, pull out | ||
| ||
the set plate on the tool and grasp both |
| |
sides of the cartridge while withdrawing it |
| |
from the barrel. |
| |
To insert the battery cartridge, align the |
| |
tongue on the battery cartridge with the |
| |
groove in the housing and slip it into |
| |
place. Snap the set plate back into place. |
| |
Be sure to close the s e t plate fully before |
| |
using the tool. |
|
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging |
|
|
|
Plug the fast charger into your power |
| I- | Vents |
source. Insert the battery cartridge so that |
|
| |
the plus and minus terminals on the bat- |
|
|
|
tery cartridge are on the same sides as their |
|
|
|
respective markings on the fast charger. In- |
|
|
|
sert the cartridge fully into the port so that |
|
|
|
it rests on the charger port floor. |
|
|
|
Check to see that the charging light comes |
|
|
|
on. When it goes out, you may remove the |
|
|
|
f uIIy charged battery cartridge. |
| i + l ( - I Terminal markinas I | |
After charging, unplug the charger from | v\\ | ||
the power source.
CAUTION :
Your new battery cartridge is not charged. You will need to change it before use.
If you try to charge a cartridge from a
When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This i s a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.
*I f you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
5
