8

FUNCTIONAL

DESCRIPTION CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.

Installing or removing battery cartridge

Always switch off the tool before insertion or removal of
the battery cartridge.
To remove the battery cartridge, withdraw it from the tool
while pressing the buttons on both sides of the cartridge.
To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone around you.
Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.

Adjusting the depth of cut

Loosen the clamping screw on the depth guide and move the
base up or down.
You can read the depth of cut by aligning the top of the notch
in the depth guide with the graduations on its right side.
(Note: This can be done for 0° bevel cutting only.)
At the desired depth of cut, secure the base by tightening the
clamping screw.
CAUTION:
Use a shallow depth of cut when cutting thin workpiece
for cleaner, safer cuts.
After adjusting the depth of cut, always tighten the
clamping screw securely.
1. Battery cartridge
2. Button
1
2
001327
1. Depth guide
2. Clamping screw
3. Base
1
3
2
003512
1. Depth guide
2. Top of notch
3. Graduation
12
3
003513