7
CAUTION:
•If the tool is operated continuously at low speeds for a
long time, the motor will get overloaded and heated up.
•The speed adjusting dial can be turned only as far as 6
and back to 1. Do not force it past 6 or 1, or the speed
adjusting function may no longer work.
ASSEMBLY CAUTION:
•Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing saw blade
CAUTION:
•Always clean out all chips or foreign matter adhering to
the blade and/or blade holder. Failure to do so may
cause insufficient tightening of the blade, resulting in a
serious personal injury.
•Do not touch the blade or the workpiece immediately
after operation; they may be extremely hot and could
burn your skin.
•Always secure the blade firmly. Insufficient tightening of
the blade may cause blade breakage or serious personal
injury.
To install the blade, loosen the bolt counterclockwise on the
blade holder with the hex wrench.
With the blade teeth facing forward, insert the blade into the
blade holder as far as it will go. Make sure that the back edge
of the blade fits into the roller. Then tighten the bolt clockwise
to secure the blade.
To remove the blade, follow the installation procedure in
reverse.
1. Blade holder
2. Hex wrench
3. Bolt
1
23
002713
1. Roller
2. Blade
3. Bolt
1
2
3
002714