Makita 4324 Dust extraction, Rip fence (optional accessory)

Dust extraction

Clean cutting operations can be performed by connecting

this tool to a Makita vacuum cleaner. Insert the hose of the

vacuum cleaner into the hole at the rear of the tool. Lower

the dust cover before operation.

NOTE:

•Dust extraction cannot be performed when making bevel

cuts.

Rip fence (optional accessory)

CAUTION:

•Always be sure that the tool is switched off and

unplugged before installing or removing accessories.

1. Straight cuts

When repeatedly cutting widths of 160 mm (6 - 9/32”) or

less, use of the rip fence will assure fast, clean, straight

cuts.

To install, insert the rip fence into the rectangular hole on

the side of the base with the fence guide facing down.

Slide the rip fence to the desired cutting width position,

then tighten the bolt to secure it.

1. Dust cover

2. Hose

002772

1. Rip fence (Guide rule)

002775

1. Hex wrench

2. Bolt

3. Rip fence (Guide rule)

4. Guide facing

002776