Makita 4324 MAINTENANCE

2. Circular cuts

When cutting circles or arcs of 170 mm (6 - 11/16”) or

less in radius, install the rip fence as follows.

Insert the rip fence into the rectangular hole on the side

of the base with the fence guide facing up. Insert the cir-

cular guide pin through either of the two holes on the

fence guide. Screw the threaded knob onto the pin to

secure the pin.

Now slide the rip fence to the desired cutting radius, and

tighten the bolt to secure it in place. Then move the base

all the way forward.

MAINTENANCE CAUTION:

•Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

To maintain product SAFETY and RELIABILITY, repairs, car-

bon brush inspection and replacement, any other mainte-

nance or adjustment should be performed by Makita

Authorized or Factory Service Centers, always using Makita

replacement parts.

1. Threaded knob

2. Guide facing

3. Rip fence (Guide rule)

4. Pin

1. Rip fence (Guide rule)

002777

002778