Makita 5007NH instruction manual Accessories, Replacing carbon brushes

001505

1

1. Triangular rule

001145

1

1. Limit mark

001515

1 2

1.Brush holder cap

2.Screwdriver

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:

•These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita service center.

•Steel & Carbide-tipped saw blades

	Combination	General purpose blade for fast and smooth rip,
		crosscuts and miters.
	Pressure treated/	Designed for fast cutting of pressure treated
	Wet lumber	and wet lumber.
	Fine cross cuts	For sand-free cuts cleanly against the grain.
	• Rip fence (Guide rule)
12	• Wrench 13