15.When operating the saw, keep the cord away from the cutting area and position it so that it will not be caught on the work- piece during the cutting operation. The tool is provided with a front grip and rear handle for two hand operation. Operate with proper hand support, proper work- piece support, and supply cord routing away from the work area.
WARNING: It is important to support the workpiece properly and to hold the saw firmly to prevent loss of control which could cause personal injury. Fig. 4 illus- trates typical hand support of the saw.
Fig. 4 A typical illustration of proper hand support, workpiece support, and supply cord routing.
16.Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. As examples, Fig. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. 6 the WRONG way. If the workpiece is short or small, clamp it down. DO NOT TRY TO HOLD SHORT PIECES BY HAND!
Fig. 5
Fig. 6
17.Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to seri- ous accidents.
Fig. 7
18.WARNING: Blade coasts to stop after switch is released. Contact with coasting blade can cause serious injury. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop.
19.Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow mate- rial supplier safety data.
7
