Installing or removing battery cartridge
.Always switch off the tool before insertion or removal or the battery cartridge.
0 To remove the battery cartridge, pull out
Battery cartridge
the set plate on the tool and grasp bothI sides of the cartridge while withdrawing it
from the tool.
0 To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure t o close the set plate fully before using the tool.
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it i s not being inserted correctly.
Charging
Plug the fast charger into your power source. Insert the battery cartridge so that the plus and minus terminals on the bat- tery cartridge are on the same sides as their
respective markings on the fast charger.Reset button Insert the cartridge fully into the port so
that it rests on the charger port floor.
Press the start button (red). The charging light will come on and charging will begin.
If the charging light does not come on, press the reset button (yellow) first, then the start button (red). If the charging light goes out within 10 seconds even after pressing the reset button and s t a r t button a couple of times, the battery cartridge is dead. (CAUTION: Wait for more than 5 seconds after the charging light goes out to press the reset button again.) Replace it with a new one. When the charging light goes out after about one our, you may remove the fully charged battery cartridge.
After charging, unplug the charge from the power source.
CAUTION :
0Your new battery cartridge is not charged. You will need to charge it before use.
*Do not keep the button pressed in with tape, etc. or the circuit will not function pro- perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
If you try to charge a cartridge from a
When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.
6