001145 |
1 |
1. Limit mark
002139 |
1 |
2 |
1.Brush holder cap
2.Screwdriver
Ni-Cd
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
After replacing brushes, insert the battery cartridge into the tool and break in brushes by running tool with no load for about 1 minute. Then check the tool while running and elec- tric brake operation when releasing the switch trigger. If elec- tric brake is not working well, ask your local Makita service center for repair.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
Recycling the Battery
The only way to dispose of a Makita battery is to recycle it. The law prohibits any other method of disposal.
To recycle the battery:
1.Remove the battery from the tool.
2.a) Take the battery to your nearest Makita Factory Ser- vice Center
or
b)Take the battery to your nearest Makita Authorized Service Center or Distributor that has been desig- nated as a Makita battery recycling location.
Call your nearest Makita Service Center or Distributor to determine the location that provides Makita battery recycling. See your local Yellow Pages under
14
