•Always secure small workpieces in a vise or similar hold- down device.
•If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery.
001902 | Installing set plate (optional accessory) |
1
2
1.Screw
2.Set plate
Model 6217D, 6317D only
Always install the set plate when using battery cartridges 1200, 1202, 1201A. Install the set plate on the tool with the screw provided.
MAINTENANCE
001145 |
1 |
1. Limit mark
001903 |
1 |
2 |
1.Brush holder cap
2.Screwdriver
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only iden- tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
After replacing brushes, insert the battery cartridge into the tool and break in brushes by running tool with no load for about 1 minute. Then check the tool while running and elec- tric brake operation when releasing the switch trigger. If elec- tric brake is not working well, ask your local Makita service center for repair.
14
