ADDITIONAL SAFETY RULES
1.Always be sure you have a firm footing.
Be sure no one is below when using the tool in high locations.
2.Hold the tool firmly.
3.Keep hands away from rotating parts.
4.When drilling into walls, floors or wherever "live" electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF THE TOOL!
Hold the tool by the insulated grasping surfaces to prevent electric shock if you drill into a "live" wire.
5.Do not leave the tool running. Operate the tool only when
6.Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
Installing side grip (auxiliary handle)
Screw the side grip on the tool securely.
Installingor removing drill bit
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing the bit.
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck by hand.Chuck key Place the chuck key in each of the three
holes and tighten clockwise. Be sure to tighten all three chuck holes evenly.
To remove the bit turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.
4
