Makita 6402 DP4700 ENGLISH

ENGLISH Explanation of general view

1Sidegrip

2Tighten

3Chuckkey

4Sleeve

5Ring

6High

7Low

8Speedcontrol screw

9Switchtrigger

0Lockbutton

qReversingswitch lever

wReversingswitch lever

SPECIFICATIONS

Model 6402 DP4700

Capacities

Steel......................................................................................................... 10 mm 13mm

Wood .......................................................................................................21 mm 36mm

Noload speed(RPM) ................................................................................ 0 – 1,200 0– 550

Overalllength ............................................................................................. 264 mm 275mm

Netweight .................................................................................................. 1.7 kg 2.0 kg

•Due to the continuing program of research and

development, the specifications herein are subject

tochange without prior notice.

•Note: Specifications may differ from country to

country.

Powersupply

The machine should be connected only to a power

supply of the same voltage as indicated on the

nameplate,and can only be operated on single-phase

AC supply.They are double-insulated in accordance

with European Standard and can, therefore, also be

usedfrom sockets without earth wire.

Safetyhints

For your own safety,please refer to enclosed safety

instructions.

Thesesymbols mean:

Readinstruction manual.

DOUBLEINSULATION

ADDITIONAL SAFETY RULES

1. Always be sure you have a firm footing. Be

sureno one is below when using the machine

inhigh locations.

2. Hold the machine firmly.

3. Keep hands away from rotating parts.

4. When drilling into walls, floors or wherever

‘‘live’’electrical wires may be encountered, DO

NOT TOUCH ANY METAL PARTS OF THE

MACHINE! Hold the machine by the insulated

graspingsurfaces to prevent electric shock if

youdrill into a ‘‘live’’ wire.

5. Do not leave the machine running. Operate the

machineonly when hand-held.

6. Do not touch the drill bit or the workpiece

immediately after operation; they may be

extremelyhot and could burn your skin.

SAVETHESE INSTRUCTIONS.

OPERATINGINSTRUCTIONS

Installing side grip (auxiliary handle) (Fig.1)

ForDP4700 only

Screwthe side grip on the machine securely.

Installing or removing drill bit

Important:

Always be sure that the machine is switched offand

unpluggedbefore installing or removing the bit.

Formachines with standard keyed chuck (Fig. 2)

Toinstall the bit, place it in the chuck as far as it will

go.Tighten the chuck by hand. Place the chuck key in

eachof the three holes and tighten clockwise. Be sure

totighten all three chuck holes evenly. To remove the

bit, turn the chuck key counterclockwise in just one

hole,then loosen the chuck by hand.

After using the chuck key,be sure to return it to the

originalposition.

Formachines with keyless chuck (Fig. 3)

Holdthe ring and turn the sleeve counterciockwise to

openthe chuck jaws. Place the bit in the chuck as far

as it will go. Hold the ring firmly and turn the sleeve

clockwiseto tighten the chuck. To remove the bit, hold

thering and turn the sleeve counterclockwise.

Switch action (Fig.4)

CAUTION:

Beforeplugging in the machine, always check to see

thatthe switch trigger actuates properly and returns to

the‘‘OFF’’ position when released.

Tostart the machine, simply pull the trigger. Machine

speed is increased by increasing pressure on the

trigger. Release the trigger to stop. For continuous

operation, pull the trigger and then push in the lock

button.To stop the machine from the locked position,

pull the trigger fully,then release it. A speed control

screw is provided so that maximum machine speed

can be limited (variable). Turn the speed control

screw clockwise for higher speed, and counterclock-

wisefor lower speed.

Makita 6402 DP4700 instruction manual ENGLISH