8
Adjusting the fastening torque
When you wish to drive machine screws, wood screws, hex
bolts, etc. with the predetermined torque, adjust the fastening
torque as follows.
The fastening torque may be adjusted by turning the adjust-
ing ring. Before turning the adjusting ring, turn the locator in
the direction of the arrow as far as it will go without forcing.
The torque is increased by turning the adjusting ring in the
direction of the arrow and decreased by turning it in the
opposite direction. Align the number 1 on the adjusting ring
with the pointer on the gear housing. Drive a trial screw into
your material or a piece of duplicate material. If the fastening
torque is not suitable for the screw, continue adjusting until
the proper torque is obtained.
CAUTION:
•The adjusting ring should be turned only within the
numbered range. It should not be forced beyond this
range.
Hook
The hook is convenient for temporarily hanging the tool.
When using the hook, pull it out in A direction and then push
it in B direction to secure in place.
When not using the hook, return it back to its initial position
by following the above procedures in reverse.
1. Locator
2. Adjusting ring
3. Pointer
123
002642
1. Hook
A
1
002646
B
002647