9
ASSEMBLY CAUTION:
•Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.

Installing or removing the bit

To remove the bit, first pull the front cap off and then pull the
bit out firmly.
To install the bit, insert it into the tool as far as it will go and
then replace the front cap.

OPERATION

Fit the screw on the point of the bit and place the point of the
screw on the surface of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw the tool as soon as
the clutch cuts in. Then release the switch trigger.
CAUTION:
•When fitting the screw onto the point of the bit, be careful
not to push in on the screw. If the screw is pushed in, the
clutch will engage and the screw will rotate suddenly.
This could damage a workpiece or cause an injury.
•Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
NOTE:
•When driving wood screws, predrill pilot holes to make
driving easier and to prevent splitting of the workpiece.
See the chart.
002655
002675
Nominal diameter
of wood screw
1/8”
9/64”
5/32”
11/64”
3/16”
13/64”
7/32”
15/64”
1/4”
Recommended size of
pilot hole
5/64”
3/32”
7/64”
1/8”
1/8”
9/64”
5/32”
11/64”
11/64”