Makita 6952 ASSEMBLY

ASSEMBLY CAUTION:

•Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Use only the driver bit or socket bit shown in the figure. Do

not use any other driver bit or socket bit.

To install the bit, pull the sleeve in the direction of the arrow

and insert the bit into the sleeve as far as it will go. Then

release the sleeve to secure the bit.

To remove the bit, pull the sleeve in the direction of the arrow

and pull the bit out firmly.

NOTE:

•If the bit is not inserted deep enough into the sleeve, the

sleeve will not return to its original position and the bit

will not be secured. In this case, try re-inserting the bit

according to the instructions above.

The hook is convenient for temporarily hanging the tool. This

can be removed without using a tool.This can be installed on

either side of the tool.

Expand the upper part of the hook in both directions and

remove it. To install the hook, follow the removal procedure

in reverse.

12 mm

(15/32”)

9 mm

(3/8”)

001266

1. Bit

2. Sleeve

1 2

001267

1. Hook

004355