Makita 6952 MAINTENANCE , ACCESS ORIES

MAINTENANCE CAUTION:

•Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

After replacing brushes, plug in the tool and break in brushes

by running tool with no load for about 10 minutes. Then

check the tool while running and electric brake operation

when releasing the switch trigger. If electric brake is not

working well, ask your local Makita service center for repair.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

ACCESS ORIES CAUTION:

•These accessories or attachments are recommended for

use with your Makita tool specified in this manual. The

use of any other accessories or attachments might

present a risk of injury to persons. Only use accessory or

attachment for its stated purpose.

If you need any assistance for more details regarding these

accessories, ask your local Makita service center.

•Screw bits

1. Limit mark

001145

1. Screwdriver

2. Brush holder cap

004357