P 3 / 5
Repair
[2] Removal/Installation of Motor from/on Gear Assembly (cont.)
INSTALLATION |
|
|
|
| |
1) Place Motor bracket as illustrated in Fig. 5, | Fig. 5 |
|
|
| |
and fasten it to Motor with two Pan head | Place Motor bracket |
|
|
| |
screws. |
| Speed change lever side | |||
so that its protruding |
| ||||
2) Aligning the protrusions on Motor bracket |
|
|
| ||
side is positioned on | Side without protrusion |
| |||
with the grooves in Gear assembly, | Red marking | ||||
the opposite side to the | |||||
assemble Motor to Gear assembly. (Fig. 6) |
|
|
| ||
red marking on Motor. |
|
|
| ||
3) Assemble Motor to Gear assembly while |
|
|
| ||
|
|
|
| ||
turning it in the clockwise direction when |
|
|
|
| |
viewed from the terminal end of Motor. |
|
|
|
| |
(Fig. 7) |
|
|
|
| |
| Pan head screw |
|
| Motor | |
|
|
|
| ||
| Motor bracket | Protruding side | |||
|
|
| |||
|
|
| Trigger switch side | ||
Fig. 6 | Fig. 7 |
|
|
| |
Grooves in Gear assembly |
|
|
| ||
Protrusions on
Motor bracket
Motor
Terminals
Gear assembly | Gear assembly | Motor |
Motor bracket
[3]Installing Speed change Lever
1)Make sure that two Compression springs are set in place on Speed change lever as illustrated in Fig. 8.
2)Install Speed change lever onto the protrusion on Gear assembly as illustrated in Fig. 9.
After installation, slide Speed change lever to either side. (Fig. 10)
Fig. 8
Compression springs
Speed change lever
Fig. 9
Speed change lever |
|
| Compression |
| springs |
| Protrusion |
Protrusion |
|
Gear assembly | Motor |
Fig. 10
Speed change lever
