5.The depth gauges (or "rakers") of the chain cutter should be checked every third or fourth chain sharpening and lowered if found to be too high.
To do this, place the guide on the gauge |
|
as shown in the figure and turn the guide | Guide |
until the wheel point fits into the ap- | I |
| |
propriate depth gauge slot in the gauge. |
|
Hang the gauge on the chain and push |
|
|
the gauge against the guide bar. Place |
|
|
the guide on the gauge and switch on |
| Chain |
the tool. Move the tool left and right to | I Guide | , |
grind away excess height of the depth | ||
gauge. |
|
|
11
