Makita BHR202 specifications Disassembly/Assembly

P 9 / 13

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-8. Swash Bearing Section (cont.)

DISASSEMBLING

6)Move Piston cylinder to the rear dead center position (Fig. 32).

7)Remove Swash bearing section from Inner housing by pulling in the direction of the arrow. Then, remove Change plate from the groove of Clutch cam. (Fig. 33).

Fig. 32

Piston cylinder

in the rear dead center position

Piston

cylinder

Swash bearing section

Fig. 33

Swash bearing section Inner housing complete

Change plate

Change plate

Clutch cam

8)Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section as a jig as follows;

*Insert Cam shaft of Swash bearing section into the Ball bearing again.

*Tilt the Ball bearing a little bit by moving Swash bearing section as illustrated to left in Fig. 34.

*Ball bearing 606ZZ can now be removed by lightly tapping the edge of Gear housing complete with plastic hammer as illustrated to right in Fig. 34.

Fig. 34

Gear housing complete

Swash bearing section used as a jig

Ball bearing 606ZZ

9)Remove Ring 8 using 1R022, 1R023, 1R281 and arbor press as illustrated in Fig. 35.

10)Remove Ball bearing 608ZZ using 1R269. Flat washer 8 and Bearing retainer can now be removed by hand. (Fig. 36)

Fig. 35

Ring 8
1R022	1R281	Ring 8
1R022
Ball bearing
608ZZ
1R023

Fig. 36

Ball bearing 608ZZ

1R269

Bearing retainer

Flat washer 8