14.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o see that keys and adjusting wrenches are removed from tool before turning it on.
15.AVOID UNINTENTIONALSTARTING. Don't carry
16.OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords intended for use outdoors and so marked.
17.STAY ALERT. Watch what you are doing, use common sense. Don't operate tool when you are tired.
18.CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized serv- ice center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Don't use tool if switch does not turn it on and off.
19.GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
20.REPLACEMENTPARTS. When servicing, use only identical replacement parts.
21.POLARIZED PLUGS: To reducethe risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This plug will fit in a polarizedoutlet only one way. If the plugdoes not fit fully inthe outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplateof the tool. A power source with voltage greater than that specified for the tool can result in SERIOUS INJURYto the user
ADDITIONAL SAFETY RULES
1.Hold the tool firmly.
2.Do not leave the tool running. Operate the tool only when
3.This tool has not been waterproofed, so do not use water on the workpiece surface.
SAVE THESE INSTRUCTIONS.
3
