Switch action
To start the tool, move the switch to the
"ON" position. To stop, move the switch to the "OFF" position.
Operation
Hold the tool firmly. Turn the tool on and wait until it attains full speed. Then gently place the tool on the workpiece surface. A finishing sander is generally used to re- move only a small amount of material a t a time. Since the quality of the surface is more important than the amount of stock removed, do not bear down on the tool.
Keep the base flush with the workpiece a t all times. Excessive pressure may damage the paper and shorten tool life.
CAUTION :
0 Do not block motor vent with your finger or hand.
0 Never run the tool without paper. You may seriously damage the pad.
MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspectionor maintenance.
The tool will stop when the carbon brusheswear to a certain length. When this occurs, both carbon brushes should be replaced.
To maintain product SAFETY and RELlABl LITY, repairs, carbon brush inspectionand replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
5
