16
Putting into operation
- Move the switch (G/6) in the direction of the arrow.
- To set the half-throttle catch, press the throttle (G/8) with
the throttle trigger lockout (G/7) pressed and then press
the catch (G/10). Release the throttle (G/8) and then the
throttle trigger lockout (G/7).
Cold start
H
- Turn the choke lever (H/9) downwards to choke the engine.
9
I
- Hold the brushcutter frimly down with one hand, as
illustrated above.
- Pull the starter handle out slowly until resistance is noticed,
then pull the starter handle out fully with a quick and forceful
movement.
- Do not pull out the whole starter cable to its full extent and
do not let the starter handle jump back, but let it slowly
automatically rewind itself.
- Repeat starting procedure until ignition is achieved.
- Turn the choke lever (H/9) back up and pull the starter
cable again until the engine starts.
- After the engine has started, press the throttle (J/8) all the
way in and release immediately. This will disengage the
half-throttle position.
- Run the engine for approximately 1 minute at a moderate
speed before commencing work.
Warm start
Similar to a cold start but without the choke.
Turning off the engine
Move switch (J/6) to the position .
STOP
Observe accident-prevention regulations!
Do not start the brushcutter until fully assembled and
inspected!
Starting the engine
- Move at least 10 feet (3 meters) away from where you filled
the fuel tank.
- Make sure you have a good footing, and lay the brushcutter
on the ground in such a way that the cutting tool is not
touching the ground or anything else.
G
8
6
710
J
6
8