P 2/ 5
Repair
CAUTION: • Repair the machine in accordance with “Instruction manual” or “Safety instructions”.
•Due to the difference of factories, the shapes and positions of actual parts are different from those shown in the following drawings.
[1]DISASSEMBLING / ASSEMBLING
[1]-1. Charger case and Terminal unit
DISASSEMBLING
Remove Charger case and Terminal unit as drawn in Fig. 1.
Fig. 1
1.Remove four Caps 13 and Tapping screws. Charger case is separated from Charger case cover.
2.Remove the connectors of Terminal unit from CN1 (connector 1) and CN2 (connector 2) of Charging circuit. Then remove Compression spring 4 from the boss of Terminal unit.
Boss of Terminal unit
Compression spring 4 Terminal unit
Charger case
Tapping screw 
(4pcs.) 
Cap 13 (4pcs.) |
|
|
Charger case cover | CN 1 CN 2 | Charging circuit |
|
ASSEMBLING
(1)Set Compression spring 4 to Terminal unit. Refer to Fig. 1.
(2)Assemble Terminal unit as drawn in Fig. 2.
(3)Assemble Charger case to Charger case cover by fastening four Tapping screws. Do not pinch the lead wires.
(4)Insert four Caps 13 into the holes of Charger case cover.
Fig. 2
1.Pass the connectors of Terminal unit through the notch and the hook of Terminal base.
2.Put the three legs of Terminal unit and
the end of Compression spring 4 into each hole of Terminal base.
3.Connect the connectors with Circuit board. (Fig. 1.)
Legs of Terminal unit (3pcs.)
Compression spring 4
Notch and hook of Terminal base
CN 1 | CN 2 | Charging circuit |
| ||
|
|
