Makita EH 450 What is not Covered Under this Warranty, Maintenance Schedule Procedure Interval

WHAT IS NOT COVERED UNDER THIS WARRANTY

This warranty does not cover any emission-related part which malfunctions, fails, or is damaged due to alterations and/or modifications such as changing, adding, or removing parts.

When a n engine is being serviced under warranty, Makita U.S.A., Inc. and any of its authorized dealers, distributors, or warranty stations shall not be liable for any loss of use of the engine, for any damage to goods, or loss of time or inconvenience.

This limited warranty also does not apply to any emission-related part which malfunctions, fails, or is damaged due to failure to follow the maintenance and operating instructions specified in the 1995and later Owner’s Manual including:

(a)Improper or inadequate maintenance of any warranted emission-related part.

(b)Improper installation, adjustment, or repair of the engine or any warranted emission-related part unless performed by a factory authorized warranty station.

(c)Failure to use recommended fuel as specified in the 1995 and later Owner’s Manual.

(d)Repairs and diagnosis performed outside of a n authorized warranty station.

(e)Use of parts which are not authorized by Makita U.S.A., Inc.

MAINTENANCE SCHEDULE

The engine owner is responsible for having all scheduled inspection and maintenance services performed at the intervals specified in the 1995 and later Owner’s Manual and to retain records of these services as having been performed. These records should be transferred to each subsequent owner of the engine. Makita U.S.A., Inc., cannot deny a claim solely because there are no records of scheduled maintenance; however, a warranty claim may be denied if the failure to perform the scheduled maintenance and inspection resulted in the failure of a warranted emission-related part. As a minimum, the engine owner is responsible for the scheduled inspection and maintenance described below which are based on the procedures described in the Owner’s Manual.

PROCEDURE	INTERVAL
(a)Check all nuts and bolts and tighten as necessary	Every 8 hours of use or daily.

(b)Check air passages and engine cylinder fins for clogging. Every 8 hours of use or daily. Remove all obstructionsas necessary.

	(c)Clean air cleaner.	Every 8 hours of use or daily.
	(d) Check the spark plug. Clean and adjust it if necessary.	Every 8 hours of use or daily.
	(e)Check the muffler exhaust port. Clean it if necessary.	Every 50 hours of	use or monthly.
	(9 Check the fuel filter. If clogged, replace it with new filter.	Every 50 hours of	use or monthly.
	(9)Replace fuel lines.	Every 200 hours of	use or annually.
	(h) Overhaulthe engine.	Every 200 hours of use or annually.
-	(i) Replace the packings and gaskets.	Every time the engine is reassembled.

,

I Q