STARTING THE MACHINE
Move at least 3 meters away from the place of refuelling. | Place the |
|
|
|
|
|
| |
Hedge Trimmer on a clean area of ground make sure that the cutting |
|
|
|
|
|
| ||
tool does not come into contact with the ground or any other objects. |
|
|
|
|
|
| ||
Cold starting (When the engine is | cold or it has been stopped for |
|
|
|
|
|
| |
more than 5 minutes or when fuel is | added to the engine. |
|
|
|
|
|
|
|
1. Push the STOP switch (1) to "I" position. |
|
|
|
|
|
|
| |
2. Squeeze first the lock lever A and then the throttle lever B. (fig.1) |
|
|
|
|
|
| ||
3. Keeping the throttle lever B depressed, then press the throttle |
|
|
|
|
|
| ||
lock C inward. (fig. 2) |
|
|
|
|
|
|
|
|
4. Keeping throttle lock C depressed, release the throttle lever B. |
|
|
|
|
|
| ||
this will lock the throttle lever B in position. (fig. 3) |
|
|
|
|
|
|
| |
5. Give a gentle push on the primer pump (2) repeatedly (7 to 10 | I |
|
|
|
|
| ||
times) until fuel comes into the primer pump. |
| EH450 |
|
| EH620 | |||
6. Move the choke lever (3)to |
|
|
| , |
| @ | ||
7. Hold the unit down firmly so you will not lose control |
|
| a / |
|
| |||
while cranking the engine. If not held down properly, |
|
| EH450 |
| ||||
the engine could pull you off balance or swing the |
|
|
| |||||
cutting blade into an obstruction or your body. |
|
|
|
|
|
| ||
8. Slowly pull the starter grip until resistance is felt and |
|
|
|
|
|
| ||
continue with smart pull until initial ignition are heard. |
|
|
|
|
| (fig. 2) | ||
9. Depress the choke lever (3)to the position |
|
|
| (fig. 1) |
| s (fig.3) | ||
pull the starter rope again until the engine starts.(I + I) and |
|
|
|
| ||||
10. As soon as the engine starts, immidiately tap and release the throttle, thus releasing the
11. Run the engine for approximately one minute at a moderate speed before aplying full speed.
Hot staring: (Restarting immediately after the engine has stopped)
When restarting a hot engine, first try the above procedure: 1, 5,7,8 .
If the engine does not start, repeat above steps
Note: | Do not pull the starter rope to its full extent and do not |
| allow the starter grip to be retracted without control, |
| ensure that it is retracted slowly. |
STOPPING THE MACHINE
1.Release the throttle lever completely.
2.Push the
"0"position, the engine rotation will become low and the engine will stop.
Gl
i n
