Installing or removing the bit
1. Change ring
1
2
008525
1.Bit
2.Chuck cover
1
008533
The bit can be secured at 12 different angles. To change the bit angle, slide the change ring forward, then turn the
Clean the bit shank before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until it engages.
1. Chuck cover
1
008528
If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way and pull the bit out.
008529
Bit angle
1. Change ring
1
008532
change ring to change the bit angle. At the desired angle, slide the change ring back to the original position. The bit will be secured in place.
OPERATION
008705
Position the bit at the location to be chipped, then pull the switch trigger. Apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency.
1 | 1. Scaling chisel |
2 | 2. Tile |
| |
002941 |
|
NOTE: |
|
•When removing tiles with a scaling chisel, apply the chisel to the bottom of tiles as shown in the figure. If you operate the tool with the chisel applied to the top surface of tiles, the service life of the chisel will be shortened.
MAINTENANCE
CAUTION:
•Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
5
