Makita HR2432 Depth gauge (optional accessory), Dust extractor attachment and dust bag (In concrete drilling operation), Dust cup (optional accessory), Installing dust extractor attachment, Installing dust bag

Depth gauge (optional accessory)

When drilling without dust extractor attachment, the

depth gauge is convenient for drilling holes of uniform

depth. Remove the dust extractor attachment. Loosen

the side grip and insert the depth gauge into the hole in

the side grip. Adjust the depth gauge to the desired depth

and tighten the side grip.

NOTE:

•The depth gauge cannot be used at the position

where the depth gauge strikes against the gear

housing.

Dust extractor attachment and dust bag (In concrete drilling operation)

With the dust extractor attachment and the dust bag

installed on this tool, you can do your work very cleanly

without dust scattered around in the work site.

CAUTION:

•These two accessories can be used only for drilling

holes in concrete. Accordingly, do not use them in

metal or wood drilling operation.

Dust cup (optional accessory)

Use the dust cup to prevent dust from falling over the tool

and on yourself when performing overhead drilling opera-

tions. Attach the dust cup to the bit as shown in the fig-

ure. The size of bits which the dust cup can be attached

to is as follows.

Installing dust extractor attachment

Loosen the clamp screw of the side grip by turning it

counterclockwise. Insert the coupling rod of the dust

extractor attachment through the coupling hole of the

side grip until the rod cannot be pushed in any further.

And then tighten the clamp screw clockwise to secure the

dust extractor attachment. The coupling rod can be

inserted from either side A or B.

NOTE:

•At some angles of the side grip with the tool, the

dust extractor attachment cannot be installed on

the tool because of the interference between the

attachment and the tool.

Insert firmly the hose of the dust extractor attachment

into the hose port of the tool until the hose hits against

the bottom of the port to be fixed firmly to the tool.

Installing dust bag

Keeping the angle of the dust bag with the tool at 90°,

insert the dust bag into the dust exhaust port of the tool.

Secure the dust bag by turning it clockwise at its frame.

1. Depth gauge

1. Dust cup

005879

005891

Dust cup 5

Dust cup 9

Bit diameter

6 mm (1/4”) - 14.5 mm (9/16”)

12 mm (15/32”) - 16 mm (5/8”)

003187

1. Clamping screw

2. Coupling hole

3. Coupling rod

1. Hose

2. Hose port

1. Dust exhaust

port

2. Frame

AB

005880

005881

005882