Makita HR2600, HR2601 P 7/ 13, [3]-5. Torque limiter section

P 7/ 13

[3] DISASSEMBLY/ASSEMBLY

Repair

REPLACING

(1) Remove Bit holder section.

(2) Remove Change lever section.

(3) Separate Gear housing from Motor housing.

(4) Remove Tool holder complete by tapping the top as drawn in Fig. 11.

Note: Flat washer 30 is located between Tool holder complete and Inner housing complete.

Be careful to lose it.

(5) Set 1R045 and 1R369 to Tool holder complete. (Fig. 12)

(6) Compress Compression spring 32 (Fig. 13), then separate Spiro lock washer 30 from

Tool holder complete by sliding a thin slotted screwdriver from the upper end as drawn

in Fig. 14. The components are disassembled. (Fig. 15)

Fig. 13Fig. 12 Fig. 14

Fig. 15

Fig. 11

Spiro lock washer 30

Tool holder

complete

Steel ball 4 (4 pcs.) Pin 6

(6 pcs.)

Driving flange Compression spring 31

Tool holder complete Spur gear 51

1R045

Compression spring 31

1R369

Tool holder complete

1R369

Upper end of

Spiro lock

washer 30

Flat washer 30 (thicker than the others) Flat washer 30 (thin)

thin

slotted

screwdriver