Rest the tool on the table with the bit end pointing upwards. This will allow the old grease to collect inside the crank housing. Wipe out the old grease inside and replace with a fresh grease (60 9). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 60 g) can cause faulty hammering action or machine failure. Fill only with the specified amount of grease. Reinstallthe crank cap and tighten with the hex wrench.
Connect the connector and reinstall the handle.
Hammer grease
.
White
CAUTION:
Be careful not to damage the terminal or lead wires especially when wiping out the old grease of installingthe handle.
Do not tighten the crank cap excessively. It is made of resin and is subject to breakage.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjust- ment should be performed by Makita Authorizedor Factory Service Centers, always using Makita replacementparts.
14
