Switch action
To prevent the trigger from being acciden- tally pulled, a
To start the tool, press in the
Fig. 18
CAUTION :
0 Before plugging in the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
When not using the tool, remove the
Operation
When cutting with this tool, the thickness of the blade i s cut as well. Therefore, your cutting line should be on either the left or right side of the groove in the kerf board. Switch on the tool and wait until the blade attains full speed before lowering gently into the cut. When the blade contacts the workpiece, gradually bear down on the handle to perform the cut. When the cut is
completed, switch off the tool and WAIT |
|
|
|
| |
UNTIL THE BLADE HAS COME TO A |
|
|
|
| |
COMPLETE STOP before returning the |
|
|
|
| |
blade to i t s fully elevated position. A thin- |
|
|
|
| |
cut piece could otherwise contact the |
|
|
|
| |
coasting blade and be thrown around dan- |
|
|
|
| |
gerously. |
|
|
|
|
|
When cutting 2 x 4 |
|
|
| Guide fence | |
Cuts of 45 degrees can be done as usual as |
|
|
|
| |
long as the workpiece i s not positioned ver- | I |
|
| ||
tically. To cut vertically positioned work- | / I | ! I | j | Workpiece | |
piece, insert a space block or scrap of wood |
| ||||
measuring 1/2" (12") | in thickness be- |
|
|
|
|
tween the workpiece and the guide fence.
10
