22
screw which secures the pointer and adjust the
pointer so that it will point to 0°.
1
2
3
009525
2. Bevel angle
Push the latch lever forward fully to release the positive
stops.
(1) 0° bevel angle
1
2
3
009512
Push the carriage toward the guide fence and
tighten the locking screw clockwise and pull
the lock lever towards the front of the saw to
secure the carriage. Lower the handle fully
and lock it in the lowered position by pushing
in the stopper pin. Loosen the lever at the rear
of the tool.
Turn the hex socket bolt on the right side of
the arm holder two or three revolutions
counterclockwise to tilt the blade to the right.
1
2
3
009511
Carefully square the side of the blade with the
top surface of the turn base using the
triangular rule, try-square, etc. by turning the
hex socket bolt on the right side of the arm
holder clockwise. Then tighten the lever
securely.
1
2
3
001819
Make sure that the pointers on the arm holder
point to 0° on the bevel scale plate on the arm.
If they do not point to 0°, loosen the screws
which secure the pointers and adjust them so
that they will point to 0°.
1
2
009490
(2) 45° bevel angle
1
2
34
009608
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm holder points to
45° on the bevel scale on the arm. If the
pointer does not point to 45°, turn the left 45°
bevel angle adjusting bolt on the side of the
arm until the pointer points to 45°.
To adjust right 45° bevel angle, perform the
same procedure described above.
1. Pointer
2. Scale plate
3. Left 45ﾟ bevel
angle adjusting
bolt
4. Right 45ﾟ bevel
angle adjusting
bolt
1. Bevel scale
plate
2. Pointer
1. Triangular rule
2. Saw blade
3. Top surface of
turn table
1. 0ﾟ Angle
adjusting bolt
2. Lever
3. Latch lever
1. Pointer
2. Lever
3. Bevel scale plate
1. Screw
2. Pointer
3. Miter scale