23
Adjustment of the laser line position For model LS1016L only
1
2
009526
1
009527
WARNING:
• Since the tool must be plugged in while
adjusting the laser line, special care must be
taken to not switch on the tool. Accidental start
up of the tool may result in serious personal injury.
CAUTION:
• Never look directly into the laser beam. Direct
eye exposure to the beam could cause serious
damage to the eyes.
• LASER RADIATION
Do not stare into beam.
NOTICE:
• Beware that impacts to the tool may cause the laser
line to be misaligned or may cause damage to the
laser, shortening its life.
Adjusting the laser line for the left side of the blade.
1
2
3
45
009514
Adjusting the laser line for the right side of the
blade.
123
009515
For both adjustments, do as follows.
1. Make sure that the tool is unplugged.
2. Draw the cutting line on the workpiece and place it
on the turn table. At this time, do not secure the
workpiece with a vise or similar securing device.
3. Lower the blade by lowering the handle and just
check to see where the cutting line and the
position of the saw blade is. (Decide which
position to cut on the line of cut.)
4. After deciding the correct position of the line in
relation to the blade, return the handle to the
original position. Secure the workpiece with the
vertical vise without shifting the workpiece from
the pre-checked position.
5. Plug the tool and turn on the laser switch.
6. Adjust the position of laser line as follows.
The position of laser line can be changed as the movable
range of the adjusting screw for the laser is changed by
turning two screws with a hex wrench. (The movable
range of laser line is factory adjusted within 1 mm (0.04")
from the side surface of blade.)
To shift the laser line movable range further away from
the side surface of blade, turn the two screws
counterclockwise after loosening the adjusting screw.
Turn these two screws clockwise to shift it closer to the
side surface of the blade after loosening the adjusting
screw.
Refer to the section titled "Laser line action" and adjust
the adjusting screw so that the cutting line on your
workpiece is aligned with the laser line.
NOTE:
• Check the position of laser line regularly for
accuracy .
• Have the tool repaired by a Makita authorized
service center for any failure on the laser unit.
1. Vertical vise
1. Workpiece
2. Laser line
1. Screw to change the movable range of the adjusting
screw
2. Adjusting screw
3. Hex wrench
4. Laser line
5. Saw blade
1. Adjusting screw
2. Saw blade
3. Laser line