Makita LSSOODWA, LSSOODZ instruction manual Cutting repetitive lengths, Carryingtool

6.Cutting repetitive lengths

When cutting several pieces of stock to the same length, ranging from 220 mm (8-5/8") to 365 mm (14-3/8"), use of the set plate (optional accessory) will facili- tate more efficient operation. Install the set plate on the holder as shown in the figure. Align the cutting line on your workpiece with either the left or right side of the groove in the kerf board, and while holding the workpiece from mov- ing, move the set plate flush against the end of the workpiece. Then secure the set plate with the screw. When the set

plate is not used, loosen the screw and turn the set plate out of the way.

NOTE:

Use of the holder-rod assembly (optional accessory) allows cutting repetitive lengths, ranging from 220 mm (8-518")to 2,230 mm (7.3ft.)

Carryingtool

Make sure that the battery cartridge is removed. Secure the blade at 0" bevel angle and the turn base at 52" miter angle to the right. Lower the handle fully and lock it in the lowered position by pushing in the stopper pin. Carry the tool by the carrying grip as shown in the figure below.

CAUTION:

*Always secure all moving portions before carrying the tool.

*Stopper pin is for carrying and storage purposes only and not for any cutting operations.

24