8
OPERAtInG yOuR AIR COMPRESSOR
EnGInE - GAS DRIvEn
1) Check entire unit for any damage.
2) Check compressor and engine oil level, ll or add if necessary.
3) Make sure gas tank is lled.
4) Read entire engine manual.
5) Starting the engine.
a) Move fuel lever to the “On” position.
- If engine is cold, move choke lever to the “Closed” position
- If engine is warm, leave choke lever in “Open” position
b) Turn engine switch to “On” position.
c) Pull starter grip lightly until you feel resistance, then pull briskly,
return starter grip gently - engine should start, if not repeat.
d) Once the engine starts running, slowly move the choke lever to
the “Open” position.
e) With the engine running properly, the compressor lls the air
receiver with compressed air, when maximum pressure (set by
the pilot valve control) is reached, the engine and compressor will
slow down to idle speed, and will return to full RPM when the cut-
in pressure is reached. The unit will continue to cycle automati-
cally until turned off.
6) Stopping the engine.
a) Turn engine switch to the “Off” position.
b) Turn the fuel lever to the “Off” position.
EnGInE IDLE SPEED MAy nEED
tO bE ADJuStED, EvEn On yOuR
bRAnD nEw unIt tO COMPEn-
SAtE fOR DIffEREnCES In
ALtItuDE. PLEASE COnSuLt thE
EnGInE OPERAtInG MAnuAL.