MAINTENANCE
CAUTION :
Always be sure that the flashlight is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.
Replacing light bulb | I |
Turn the ring counterclockwise and remove the ring, reflector and bulb together. Pull the bulb holder out of the reflector. Pull the bulb out of the bulb holder after turning the bulb slightly clockwise.
To install a new bulb, follow the re- moval procedure in reverse. There are three notches in the bulb holder. Set the bulb in the center notch.
Bulb
r holder
Set the bulb here.
CAUTION :
0 Replacement light bulbs are readily available from your Makita dealers, or Makita Authorized or Factory Service Centers. Always specify bulb type (9.6V, 500 mA).
*Never attempt to short the bulb I | I |
3
