STORAGE
When storing the machine for a long time, drain the fuel from the fuel tank and carburetor as foll,ows:
1.Drain all fuel from the fuel tank. Gently push on the primer pump repeatedly until all fuel is expelled out of the primer pump. Properly dispose of the fuel in accordance with all local laws.
2.Remove the spark plug and add a few drops of oil into the spark plug hole. Then, pull the starter gently to assure that an oil film coats the engine inside, then insert and tighten the spark plug.
3.Clear or blow any dirt or dust from the nylon cutting head and engine housing; wipe them with an
REASSEMBLY INSTRUCTIONS
Reassembling the drive shaft and the engine.
Screw M5x18
The shaft and the engine on this machine have been assembled in the factory. If you remove the shaft (example, for maintenance) carefully reassemble it as shown below:
1. Loosen the screws M5x18 and insert the drive |
| |
shaft into the holder case (Fig. 16). | 0 | |
Note: |
|
|
i). Always insert the drive shaft into the holder |
| |
case fully (approx. 60"; |
| |
shaft resists full insertion | of the drive shaft, |
|
try to insert it again while slightly rotating the |
| |
support washer on the gear case.
ii). Be cautious not to allow the switch cords to be pinched between the holder case and the grip end.
2. After making sure that the drive shaft is installed fully and properly, tighten the screws M5x18 to secure the drive shaft.
3. Insert the nipple of the throttle wire through the square hole in the grip until it fits into an inner square hole in the moving part which is inside the grip. The nipple should move when the throttle lever is squeezed (Fig. 17).
Note: Squeeze the throttle lever to make sure that the throttle wire moves smoothly.
4. Connect the two switch wires to the engine wires by inserting one into the other.
5. Cover the throttle wire and switch wires with split tubing.
Note:
It is easier to install the split tubing if the bullet connectors are partially pushed into the motor cover to remove slack from the wires (Fig. 18).
Holder case
Fig. 16
Nipple of throttle wire
Fig. 17
-
Fig. 1 E
10
